Wednesday, 2 December 2020
Symantec Norton Ghost Boot Disk Blank DOS Box Screen Ghost Wont Run
Having problems getting Symantec/Norton Ghost? If all you are getting is a command prompt within Windows PE (as shown below) then check the amount of RAM you have! In the example below the laptop only has 256MB of RAM by upgrading to 512MB (or more) Ghost then loaded OK.
Subscribe to:
Posts (Atom)
Top 10 Posts Read From The Last 30 Days
-
An Imation SuperDisk LS-120 Floppy Disk Drive arrived in the post today! Works perfectly in Windows XP but I can't find a driver that wi... -
This came all the way from Israel today (vie eBay): I didnt realise but it has both Windows 95 and Windows 98 restore options/CDs. I... -
I've got a couple of Compaq and HP iPAQ's (one even has a charger) but until now I've not had a keyboard for any of them. Once... -
Way before the Covid19 Pandemic came to light I picked up a job-lot of laptops from a car boot sale and I'm slowly starting to refurbish...
-
According to the Service Manual for the Compaq Armada 1700 series, you press F10 to enter the BIOS. Unlike modern computers, the BIOS pro... -
I recently won 240+ 3.5" floppy disks on eBay so I have been looking for a way to reliably mass format and test them. I did ask on a F... -
Have you got a Vintage or Retro Toshiba laptop that wont boot as it has a BIOS Password set? Then what you need is a KEY Disk!... When y... -
On the IBM ThinkPad 380D laptop the CMOS batter for the BIOS is located under the RAM cover on the bottom of the laptop so (after first rem... -
Step 1 - On the bottom of the laptop, remove the two torx headed screws holding the bezel in place that gives you access to remove the keyb... -
First things first, TURN IT OFF and UNPLUG THE MAINS ADAPTER. Obvisously, until you open up the laptop there is no way of knowing what kind ...
